Just over a week ago my innokin taste mpv developed a fault as in it would,nt turn off , so i sent it back to the vender -in the mean time i needed a backup a vamo and a AGA T2 from steath vapes(gr8 customer service BTW) Im as pleased as punch with my vamo but dispite watching bucket loads tutorials vids on the AGA T2 ive not been able to set it up successfully.
ive tried .15 .20 and .25 kanthal wire on 400 mesh as little as 3 raps and as many as 5 . im using a clipper lighter to deoxizize the mesh using water to cool it down then burning ejuice straight off the wick .Up untill earlier on this morning my oym reading was all over the place so i tried again after watching one of Todds videos using the PeterKay/Kayne method.
I didnt have a drill bit to hand but using a machine screw i raped a coil with 4 raps and a 1.7oym reading The coil using glowed bright red.i carefully put it over the wick and half filling my tank and making sure the airhole lines up with the wick im finding that the draw is sort of airey and loose and im not getting half the taste i do with my vivi nova or my rebuildable clearo. ive tried taking the filler screw out/leaving it in going up and down with the voltage .
The only thing i havnt tried is a silica wick, would i get a better flavour as my both my vivi nova and my clearo use silica and got no complaints with them.
im using a 50/50 blueberry crunch diy ejuice , not sure if that would make any difference thou .
If anyone can suggest anything that will improove a better draw and better flavour i would be more then grateful .